Gaskets, seals and rubber balls for pumps and pressure washers

The O-Rings produced by Tedeschi Gomma, are especially applied on centrifugal pumps, which have a mechanical sealing characteristic, consisting of one part in steel and another one in graphite, where the last one has a place for the O-Ring.

On these types of grips you might in time experience small drops. If you position the spray protection gaskets externally on the shaft, they serve to avoid that the liquid becomes centrifuged externally when it flows along the pump shaft.

The sand cover gaskets produced by Tedeschi Gomma are applied at the shaft of the centrifugal electrical pumps, between the cooling fan and the back cover of the engine. This to prevent the dust aspirated by the fan finishes inside the engine, damaging the bearing which by consequence leads to more serious failures.

The flat gasket and flat washer gasket produced by Tedeschi Gomma are applied as cable ties sealing pumps.

The rubber balls produced by Tedeschi Gomma are applied as retaining valves at submerged and submersible pumps and at systems for priming sewage pumps.

The custom products applied at electrical pumps are spigots, grommets, rubber handles, taps, bushings and cable bushings, caps and membranes.

The volumetric compensation membrane performed at the design of the client, is another strength of our experience, both for the high number of models manufactured and for the specific study of the fatigue resistance and the elastic responsiveness of the compound developed by the laboratory of Tedeschi Gomma.

Tedeschi Gomma produces gaskets and seals in rubber for hand sprayers. Rubber items used for these applications are: FLAT GASKETS and CUSTOM PRODUCTS.

The flat gaskets produced by Tedeschi Gomma are applied at frontal sealing.

The custom products are primarily piston janglers which draw and compress the agrochemicals during the manual operation of lever pumping of the hand sprayers, used for weeding and spraying manual.

Tedeschi Gomma produces gaskets and seals in rubber for grease guns and lubrication equipment. Rubber items used for these applications are: O-RINGS, LIP SEALS TYPE UM, LIP SEALS TYPE DI, SEAL TYPE FT and CUSTOM PRODUCTS.

Tedeschi Gomma produces gaskets and seals in rubber for pressure washers. Rubber items used for these applications are: FLAT GASKETS and CUSTOM PRODUCTS.

The flat gaskets produced by Tedeschi Gomma are applied as vibration dampening spacers for pressure washers. 

The custom products applied at the pressure washers are cable bushings, supporters and curved air intake.